Setting Up The Ems-503; Zero Ft; Set Hobbs; Temp In … - MGL Avionics Stratomaster Smart Single EMS-503 Manual

Setting up the EMS-503

Press the Menu key to enter the menu. You can move forward and backwards in the menu by
using the + and – keys. To change or select a menu item, move the highlight to the desired item
and then press the Menu key. To end an edit or function, press the Menu key again.
To exit the menu and continue normal operation, select the ***Done*** function and press the
Menu key. Note, all changes you have initiated during your session will only be remembered by
the instrument if you exit the menu using the ***Done*** function.

Zero FT

This function allows you to set the flight timer to zero. The flight timer counts hours and minutes
while the engine is running.

Set Hobbs

This function allows you to set the hobbs meter to your current engine running time.
Use the plus and minus buttons to change the indicated part of the hobbs reading. Use the Menu
button to change from hour hundreds to hours to minutes.
Moving the update cursor below the numbers past the minutes field on the right ends the edit of
the hobbs meter reading and stores any changes.
Temp in ...
Choose your temperature units. You can select Degrees Celsius or Degrees Fahrenheit.