Sony Ericsson K700i Working Instruction, Mechanical page 6

Step-by-Step Instructions
6 Remove the joystick button with your fingers.
NOTE!
The joystick may be tight fitted to the switch.
7 Use front opening tool to separate the metal
carrier from the frame. Two frame snap fit
hooks, located in the middle section, shall be
released.
Place the opening tool close to the metal carrier
and press down until the hook moves to the
frame wall (1).
Angle the opening tool, as the picture shows (2),
until the metal carrier is released. Do the same
on the opposite side of the metal carrier.
Remove the metal carrier.
The system connector plug will most likely fall
out when releasing the metal carrier (3). If not
remove the plug.
3/00021-1/FEA 209 544/83 A

Company Internal Sony Ericsson Mobile Communications AB
Working Instruction, Mechanical
6(37)