Sony Ericsson K700i Working Instruction, Mechanical page 5

Step-by-Step Instructions
1C-1H hooks:
NOTE! Now use the K700 Front opening tool
and NOT the screwdriver for snaphooks 1C-1H.
Angle the new K700i/Front opening tool, as the
picture shows, when releasing the hooks.
Place the K700i/Front opening tool (in correct
angle), close to the frame and press down to
release the snap fit hooks. Begin with snap
hooks marked (3). No hard force is needed.
Whereupon hooks are released the gap between
front and frame increases.
Continue to release hooks (1E/F resp 1G/H).
NOTE! You might need to repeat releasing the
hooks a few times as they easily get back to
original location.
The frame is firmly clamped on to the top of the
phone and cannot be dislodged easily.
Gently lift the front cover upwards to separate
front and frame. The two top hooks will be
released with a "break" sound, this sound is
normal. As long as you remove the front gently
there will be no damage on the front or its snap
hooks.
The keypad might fall out. If not remove it with
your fingers.
5 NOTE! Be careful and don´t touch the display.
Remove the 4 screws.
NOTE!
Removed screws cannot be reused and must be
scrapped.
3/00021-1/FEA 209 544/83 A

Company Internal Sony Ericsson Mobile Communications AB
Working Instruction, Mechanical
5(37)