Sony Ericsson K700i Working Instruction, Mechanical page 16

Step-by-Step Instructions
6 Place the metal carrier over the frame assembly.
Assure that system connector plug latches are
under the frame (1).
Place the front opening tool close to the metal
carrier (2) and press down until the frame hook
fastens the metal carrier with a "click" sound.
Use the white display-guiding pin (3 close to
screw opening) to get the metal carrier in the
correct position.
Do the same on the opposite side of the metal
carrier (4).
Press on the phone, as the picture shows, to
assure that the hooks are properly fitted into the
metal carrier.
NOTE!
Another "click" sound might be heard.
7 Press the joystick assembly onto the joystick
switch pin.
NOTE!
If you have assembled a new joystick:
Remember to assemble the black/grey
joystick dust gasket, see picture below.
8 Assemble new screws in the order 1-4.
NOTE!
Use torque screwdriver set to 18 Ncm.
3/00021-1/FEA 209 544/83 A

Company Internal Sony Ericsson Mobile Communications AB
Working Instruction, Mechanical
16(37)