Advertisement
01/20
ASSEMBLY, OPERATION, PREVENTITIVE MAINTENANCE
1. FEATURES & MODELS
The Borum Industrial Quality Air Actuated Hydraulic
booster cylinder, to move hydraulic oil within the cylinder up & down. It adopts a heavy duty hydraulic
design combination of compressed air and hydraulic pressure, to create, strong jacking capacity and
low lifting clearance in one jack. This truck jack lets you really get under your loads with a 210mm
minimum height. Designed to lift trucks, buses and other large commercial and agricultural vehicles
with maximum stability.
2. ASSEMBLY
Assembly of Handle: After removing from the packing material, make sure the product is in
perfect condition and that there are no visible damaged parts. Dispose of the packaging material
responsibly.
1. Attach the height adaptor holder to the lower handle with two (2) U-bolts and nuts.
2. Tighten the nuts to secure the height adaptor holder to the handle.
3. Place the height adaptors into the adaptor holder.
4. Place the handle assembly into the handle socket and secure with bolt.
3. BEFORE FIRST USE
Conduct a thorough visual inspection checking for any abnormal conditions, such as cracked welds,
and damaged, loose, or missing parts.
1. Verify that the product and the application are compatible.
2. Pour a teaspoon of good quality air tool lubricant into the air supply inlet of the lift control valve.
Connect to air supply and operate for 3 seconds to evenly distribute lubricant.
3. Check to ensure that the pump operates smoothly before putting into service. Replace worn or
damaged parts and assemblies with manufacturer approved parts only.
4. This product is fitted with a standard 1/4" NPT air fitting. To change the fitting install a 1/4" NPT
fitting of your choice, ensure the thread tape or compound is used to seal the connection.
Bleed Air from the Garage Jack:
Air can accumulate within a hydraulic system during shipment or after prolonged use. This
entrapped air causes the jack to respond slowly or feel "spongy".
To remove the air:
Open the hydraulic system by turning the control knob anti-clockwise.
1.
Depress the air actuator and pump air through the system for 15 seconds.
2.
Turn control knob clockwise and unit should be bled.
3.
Made in China to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
Truck Jack
utilises compressed air to activate a
B2003T
P a g e
| 3
Advertisement
