Cleaning The Spa; Spa Repair - Bestway LAY-Z-SPA VEGAS Owner's Manual

1.
Remove the filter set from
the spa.
5.
Connect the hose
adapter to your garden
hose and attach the
hose adapter to the
spa's B adapter.
For #54129, attach
the hose adaptor to
the drain adaptor
on the bottom of
the SPA.
9.
Use the inflation hose to blow dry the
pump and the spa pool. Connect the
inflation hose to adapter A on the pump
and press the Lay-Z-Massage button to
activate the blower.
P6931/P6930/P6613
A

Cleaning the spa

NOTE: DO NOT use hard brushes or abrasive cleaners.

Spa Repair

For Spa #54112, #54123 and inflatable
cover #54113, #54129
If the spa is torn or punctured, use the
provided heavy-duty repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
2.
Insert the 2 stopper caps
onto the spa's inlet and
outlet pipes.
6.
With your hose
positioned in a selected
drain area, remove the
lower stopper cap from
inside the spa to release
the water.
For #54129, remove the
drain cap on the bottom of
the SPA to
release the
water.
10.
Make sure the pump is dried thoroughly.
Clean the pump's inner housing using a
towel. Tilt the pump to drain the residual
water in the hose. It is recommended to
use the inflation hose to aim to dry the
Pump's adapter B.
Detergent residues and dissolved solids from bathing suits and chemicals may build up on the spa
walls. Use soap and water to clean the walls and rinse thoroughly.
For Spa #54113, #54129 (Not including inflatable cover)
If the spa is torn or punctured, use the provided PVC repair patch or Polyester 3-ply
patch and glue (not included) following these steps:
1. Clean and dry area to be repaired.
2. Cut the provided PVC or Polyester 3-ply patch to appropriate size.
3. Use glue to coat the one side of the newly cut patch. Make sure the glue is evenly
distributed.
4. Wait for 30 seconds and then place the cut patch with glue over the damaged area.
5. Smooth out any bubbles of air that may be trapped underneath, and press firmly for
two minutes.
6. The product is once again ready for use. Repeat this process should further leaks
occur.
3.
Disconnect the
pump from the spa.
7.
Once most of the spa
water is drained, open
the bottom drain valve
on the pool floor to
remove any remaining
water.
P6931/P6930/P6613
C
A
21
4.
Screw the adapter
cover onto adapter A of
the spa.
8.
For #54112, #54123: Unscrew
the valves to deflate the spa.
8.
For #54113, #54129: To deflate,
unscrew the air-valve counter
clockwise from the air intake
valve, press the spring valve and
turn clockwise.
11.
Use a new filter cartridge
when resuming spa use.
Please refer to page 19
for Filter Cartridge
Replacement.
S-S-002097