Pump Test - Bestway LAY-Z-SPA VEGAS Owner's Manual

Pump Test

1. Insert the plug into a mains socket. The LED
automatically displays current water
temperature.
2. Press the "Test" button. All the indicator lights turn
off, and the pump gives a warning beep.
3. Unplug and then plug the pump back in to start the
system. The pump is ready to use.
WARNING: RISK OF ELECTRIC
SHOCK. The pump must be
tested before each use.
WARNING: Insert the plug into a residual current device (RCD)
protected power outlet only.
WARNING: Before inserting plug into a power outlet, make sure the
current rate of the power outlet is suitable for the pump.
WARNING: Do not use the pump if this test fails.
ASSEMBLY: VEGAS
1.
Spread out the spa and
leatheroid cover and make sure
both are right side up.
4.
NOTE: Do not
use an air
compressor to
inflate the pool.
Use the inflation hose to
inflate the chambers
according to the printed
numbers 1 on the spa
and 2 on the cover.
1
Spa
2.
Connect the inflation
hose to adapter A on the
pump.
Screw the Open the top cover of the
screw-valve onto the screw-valve, insert the
air intake valves inflation hose and inflate.
marked with No. 1 on Once inflation is finished,
the leatheroid cover. fasten the top cover of the
screw-valve.
(#54112)
3.
2
Cover
12
Test
Test
As previously outlined, test the
pump and press the
Lay-Z-Massage button to activate
the pump.
Test
NOTE: Before use
the Lay-Z-Spa
Vegas, always
make sure that all
of the inflatable
chambers are
properly inflated
and that there are
no folds.
Open the top leatheroid cover
and reverse. Insert the inflation
hose onto the valve to inflate.
When the inflation is finished
close the valve.
S-S-002097