Bestway LAY-Z-SPA VEGAS Owner's Manual page 16

5.
Connect the pump to the spa by
lining up the letters (A to A, B to B
and C to C). Securely hand-tighten
the adapters. Check all rubber seals
are in place.
8.
Using a garden hose, fill the spa to the water level between
maximum and minimum printed on the spa wall.
NOTE: Before filling, ensure the
bottom drain valve is secured.
To avoid pump failure, water
level must reach the minimum
water line but not exceed the
maximum water line.
9.
To heat the water, put the cover on, lock the velcros, and push the heat button (see page 18).
WARNING: Do not run the Lay-Z-Massage system when the
cover is attached, air can accumulate inside the spa and cause
irreparable damage and bodily harm.
WARNING: This spa cover is not a safety cover and is not a
substitute for adult supervision; children must be supervised
around the spa at all times.
Note: We recommend you take a shower before
using your Lay-Z-Spa, as cosmetic products,
lotions, and other residues on the skin can quickly
degrade water quality.
ASSEMBLY: PALM SPRINGS
1.
Spread out the spa and cover and
make sure both are right side up.
6.
Remove the two stopper caps from
the inside of the spa's inlet and
outlet pipes.
2.
Connect the inflation hose to adapter
A on the pump.
16
7.
Screw the filter set to the inside of
the spa's outlet pipe.
NOTE: Must screw in
lower position.
NOTE: Do not sit on the
filter set.
X
(#54129)
3.
As previously outlined, test the pump
and press the Lay-Z-Massage button
to activate the pump.
Test
S-S-002097