Installation; Selected Location; Gfci Test - Bestway SaluSpa 54124E Owner's Manual

INSTALLATION

Selected Location

IMPORTANT: Because of the combined weight of the SaluSpa, water, and users, it is extremely
important that the base where the SaluSpa is installed is smooth, flat, level and capable of
uniformly supporting the weight for the entire time the SaluSpa is installed (not on the carpet or
other similar material). If the SaluSpa is placed on a surface, which does not meet these
requirements, any damage caused by improper support is not covered under the manufacturer's
warranty. It is the responsibility of the SaluSpa owner to assure the integrity of the site at all
times.
1. Indoor Installation:
Be aware of special requirements if you install the spa indoors.
• Humidity is a natural side effect with SaluSpa installation. Determine the effects of moisture on exposed wood,
paper, etc. in the proposed location. To minimize these effects, it is best to provide plenty of ventilation to the
selected area. An architect can help determine if more ventilation is needed.
2. Outdoor Installation:
• During filling, draining or when in use, water may spill out of the spa. Therefore the SaluSpa should be installed
near a floor drain.
• Do not leave the spa's surface exposed to direct sunlight for long periods of time.

GFCI Test

IMPORTANT: RISK OF ELECTRIC SHOCK. THE GFCI MUST BE
TESTED BEFORE TURNING ON THE PUMP EACH TIME.
WARNING: The GFCI plug must be tested before each use to avoid risk of electric shock.
WARNING: Before inserting plug into a power outlet, make sure the current rate of the power
outlet is suitable for the pump.
WARNING: Do not use the pump if this test fails and contact our Aftersales Service.
NOTE: When inflating, you will notice that air will be expelled from the
area where the air hose connects to the pump, this is normal for
technique requirements.
NOTE: Do not use an air compressor to inflate the pool.
NOTE: Do not drag the pool on rough ground as this may cause
damage to the pool liner.
NOTE: Inflation time for reference only.
NOTE: Pressure gauge is for inflation purpose only, and the
value of the pressure gauge is just for reference, should not be
used as a precision instrument.
Air Valve Check
(for spa with quick inflation/deflation valve)
Always check the air valve carefully before inflation to ensure there is
not an air leak. If the air valve is loose, use the provided wrench to
fasten the air valve following these steps:
With one hand, hold the backside of the air valve from the inner side of
the spa wall and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Do not adjust the air valve connector when the spa is in use.
S-S-004676/21x28.5cm/54124E,54130E,54149E,54155E,54157E/美国规Salu SPA说明书/JS-YF-2016-B-05547/英
1. Plug the GFCI into a power outlet, the indicator
turns red.
2. Press the test button, the indicator turns off.
3. Press the reset button, the indicator turns red and
the spa is ready for use.
09
S-S-004676