3. Drive three screws into the screw holes on top of the mini high-speed dome by
half, align the dome with the notch of the base, continue to drive the screws
into the screw holes of the base, and tighten the screws.
2.2 Network Connection
The device can be connected to network in two ways. The first way is to connect to
the network by means of Ethernet cable, and the second way is to connect to
wireless network (optional).
.............................. Connect by Ethernet Cable
(1)
Use Ethernet cables to connect the device to network or directly to computer.
(2)
Connect the power supply of the device.
(3)
During normal connection, if it is a 10M network, the orange lamp is always
on; if it is a 100M network, the green lamp is also on. The physical connection
with network is completed after the lamp shining.
(4)
In the "Start" menu, select "Programs"--"Accessories"--"Command Prompt",
and input the ping command to the device address (e.g.: type in "ping
192.168.1.88"). If "Request timed out" does not pop up, the device is
successfully connected to network.
Installation and Network Configuration
13