Advertisement
The LMPC-600 can be mounted using one of three possible methods:
• Mounted to the ceiling using the included plastic mounting plate
• Mounted to a hanging threaded rod, for open ceiling environments, using the included threaded rod adapter
• Recessed mounting, using the optional LMPC-600-RPM Recessed Plenum Mounting Kit
Ceiling Mount
1. Attach the mounting plate to the
ceiling with the three included 1"
mounting screws.
2. Twist the LMPC-600 clockwise to
lock it onto the mounting plate.
Twist to
Lock
NOTE: Pull protective battery
tab before installation
to power the sensor.
Sensor Masking
The LMPC-600 ships with three 90 degree snap in plastic parts that can be used to
mask the sensor coverage.
Mask
MOUNTING AND INSTALLATION
Threaded Rod Mount
The threaded rod adapter can mount to a
3/8"-16, 1/4"-20, or 1/2"-13 hanging threaded
rod.
1. Screw the adapter onto the rod.
2. Attach the mounting plate to the adapter
using the included 10mm screw.
3. Twist the LMPC-600 clockwise to lock it
onto the mounting plate.
Threaded Rod Size
3/8"-16, 1/4"-20,
or 1/2"-13
Mounting Bracket
Twist to
Lock
(Wake and Push to Pair)
3
Recessed Mount, using the
LMPC-600-RPM
Threaded hole - 1/2"-13
Threaded hole - 3/8"-16
Threaded hole - 1/4"-20
Hanger attachment
feature, for use when
local safety or seismic
requirements are
Config Button
applicable.
Note: Once the
sensor is attached
to the recessed
mount, the sensor
will be firmly
in place.
1. Using a 3 3/4" hole saw, cut a hole
in the ceiling.
2. Raise the spring loaded arms so
they fit through the hole.
3. Release the arms. The LMPC-600
will loosely clamp to the ceiling.
4. Hold the edges of the recessed
mounting plate to prevent it from
moving, then twist the LMPC-600
clockwise to lock it onto the mounting
plate.
Cut hole with 3 3/4" hole saw
Twist to
Lock
Spring
Arm
12 Gauge
Wire Hanger
Advertisement
