Connecting Wires; Mounting The Sensor - LEGRAND Wattstopper DT-305 Manual

360 dual technology • low voltage occupancy sensor (version 3) with manual on feature

Hide thumbs

Table Of Contents

Table of Contents

Available languages

• Care should be taken to separate high voltage power from low voltage (Class 2) control wiring.

• All connections to sensor are low voltage, Class 2.

Standard wiring with two local off switches

Neutral

White

BZ-200

Hot

Black

Power Pack

**Ground

** BZ-200 Power Pack

must be grounded to

ensure signal integrity,

not for safety ground.

Directly to Ceiling

1. Attach the plastic spring clips to the edge of the sensor in the slots provided.

2. Cut a 3.5" to 4" round hole in the acoustic ceiling tile at the mounting location. A 3.5"

hole is recommended for a secure fit.

3. Pull the low voltage wire from the power pack to the sensor through the hole.

4. Connect the low voltage wires to the appropriate terminals on the sensor.

5. Push the sensor up through the hole until the Spring Clips hold the sensor securely

in place.

6. Snap the front cover onto the sensor.

Using an Octagonal J-Box

1. Pull the low voltage wires from the power pack into the J-Box through the conduit

knockout.

2. Connect the low voltage wires to the appropriate terminals on the sensor.

3. Loosen the appliance mounting screws attached to the J-Box.

4. Align the sensor in the J-Box so that the mounting screws on the box match the key

holes on the sensor's rear housing.

5. Push the sensor up into the J -Box and twist it so that the mounting screws are seated

in the keyhole slots.

6. Tighten the two screws to secure the sensor to the J-Box.

7. Snap the front cover onto the sensor.