Table of Contents
Advertisement
Operating Instructions and Parts Manual
S
5:
tep
Screw pipe tee onto pipe nipple.
Hand tighten.
All connections will be fully tightened
in steps 7 & 8.
S
6:
tep
Remove protective cover from tank's outlet/
inlet, then screw hose-barb elbow onto
tank.
Hand tighten.
All connections will be fully tightened in
steps 7 & 8.
S
7:
tep
With a pipe wrench, tighten pipe tee
1 to 1-1/2 turns, aligning hose-barb with
pump as shown. (Make sure pipe tee and
nipple are tight to prevent leakage.)
S
8:
tep
Tighten hose-barb 1 to 1-1/2 turns. Make
sure the hose-barb points toward the top of
the tank when tight.
Do NOT overtighten hose-barb elbow.
Some hose-barb elbows are made of
plastic, and overtightening may cause
damage.
www.waynepumps.com
HOSE-BARB
ELBOW
SWS50-8.5FX
5
Advertisement
Table of Contents
