Table of Contents
Advertisement
Operating Instructions and Parts Manual
S
1:
tep
NOTE: Remove pump from stabilizing mount,
used for shipping and packing.
With motor end of pump facing the "outlet /
inlet" end of the tank, mount pump to tank
with the provided carriage bolts, nuts and
washers as shown (right).
For easy installation, install bolts through
bottom.
The bolts can be entered in any slot
to secure the pump providing they are
positioned diagonally from one another.
NOTE: Pump CAN move slightly, even after
bolts are placed. This provides flexibility when
installing into plumbing.
S
2:
tep
Wrap ALL external pipe threads with
plumbers seal tape or other thread
sealant.
NOTE: Start tape about two threads
from bottom of fitting. Wrap tape 2 or
3 turns in the direction of the threads
overlapping each turn. Smooth tape
over threads to make sure there are no
bubbles or loose pieces of tape.
S
3:
tep
Looking at the pump from the motor
end, screw pipe nipple into the
pump discharge located on the left.
All connections will be fully tightened
in steps 7 & 8.
S
4:
tep
Screw straight hose-barb into pipe tee.
All connections will be fully tightened in
steps 7 & 8.
4
MOTOR END
HEX NUT
WASHER
CARRIAGE
BOLTS
TANK OUTLET/INLET
HOSE BARB
(THREAD BOTH ENDS)
PIPE NIPPLE
MOTOR END
STRAIGHT
HOSE-BARB
TANK
OUTLET/INLET
PIPE NIPPLE
TEE
FITTING
HEX
NUT
WASHER
www.waynepumps.com
Advertisement
Table of Contents
