Cisco TelePresence MX700 Installation Manual page 13

Installation guide for Cisco TelePresence MX700 Single camera - Floor stand
8
Lift right monitor onto floor stand
D
65 kg / 144 lb
Make sure that the screw with
1
wing nut enters the center slot on
both sides.
Keep the outer side a bit lower than
the side toward the other monitor
when lowering the monitor onto the
floor stand.
Do not let go of the monitor before it
is securely placed on the floor stand.
78-100218-03A0 | 2018 JUNE | © 2018 Cisco Systems, Inc. All rights reserved.
Front view
Front view
Rear view
Rear view
Tighten the wing nuts
2
on both sides. They are
accessed from the sides
of the monitor.
Page 13