Adjustments; Steering Adjustment - Exmark Z Turf Equipment Z-SPRAY Operator's Manual

Maintenance
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Wait for muffler to cool.
3. If any breaks in the screen, welds, or deflector are
observed, replace arrester.
4. If plugging of the screen is observed, remove
arrester and shake loose particles out of the
arrester and clean screen with a wire brush (soak
in solvent if necessary). Reinstall arrester and
deflector onto exhaust outlet.
Copper-Based Anti-seize
Service Interval: As required
Copper based anti-seize is used in the following
location:
On the rear axle shafts.
• Apply each time the rear wheel(s) has been
removed and reinstalled.
• Apply yearly or before storage.

Adjustments

Steering Adjustment

1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Check the tire pressure (see Check Tire
Pressures section).
3. Center and secure the steering control by placing
a long bolt into the outside holes on the steering
control and through the control column.
1. Control column
4. Measure the distance between the two front tires.
Take one measurement from the front and rear
as shown in Figure 36.
56
Figure 35
2. Outside holes
g305444