Exmark Z Turf Equipment Z-SPRAY Operator's Manual page 17

Figure 7
1. Fence
2. Flowers
Spray Display
Located on the LH side of the control panel. It shows
the pressure setting number from 5-60 PSI in 1 PSI
step sizes. The engine on hours are displayed when
the pressure controller is off.
The Spray Controller Display also displays engine on
hours of operation.
A pressure transducer is used to display the pressure
at the present time.
The Spray Pump Switch, located to the right of the
Sprayer Controller Display, turns on the sprayer
motor, sets the sprayer pressure, and turns on the
agitation motor. Push on the top of the switch one
time to turn the sprayer to "ON"; continue to tap
the top of the switch to increase the sprayer pressure.
Tap the bottom of the switch to decrease the speed;
push and hold the bottom of the switch to turn the
sprayer "OFF".
Note: The pressure control can be turned off at
any pressure setting. It is not necessary to decrease
the pressure until it turns off. The previous pressure
setting will display when the control is powered back
on.
g027373
3. Side deflector lowered
Spray Display
1. Information screen
Spread Display
Located on the RH side of the control panel. The
Spreader Controller displays the speed setting number
from 5-100% in 5% step sizes. A circle (0) will display
when the control has been turned 'OFF'.
The Spread Pump Switch, located to the left of the
Spreader Controller, turns on the spreader motor and
sets the speed of the impeller. Push on the top of the
switch one time to turn the spreader "ON"; continue
to tap the top of the switch to increase the impeller
speed. Tap the bottom of the switch to decrease the
speed; push and hold the bottom of the switch to
turn the spreader "OFF".
Note: The impeller speed control can be turned off
at any speed rate. It is not necessary to decrease the
speed until it turns off. The pervious set speed will
display when the control is powered back on.
During key 'ON', firmware part number and spreader
hours are displayed momentarily until the spreader
off symbol is displayed. At key 'OFF', the display
turns off after 3 seconds.
17
Operation
Figure 8
2. LED status light
g305359