Specifications; Systems - Exmark Z Turf Equipment Z-SPRAY Operator's Manual

Specifications

Systems

Engine
• Engine Specifications: See your Engine Owner's
Manual
• Engine Oil Type: 4-Cycle Engine Oil
• RPM: Full Speed: 3600 ±100 RPM (No Load)
Fuel System
• Capacity: 1.59 gal. (6.1 L)
• Fuel Recommendations:
– For best results, use only clean, fresh, unleaded
gasoline with an octane rating of 87 or higher
((R+M)/2 rating method).
– Oxygenated fuel with up to 10% ethanol or
15% MTBE by volume is acceptable.
– Do Not use ethanol blends of gasoline (such
as E15 or E85) with more than 10% ethanol
by volume. Performance problems and/or
engine damage may result which may not be
covered under warranty.
– Do Not use gasoline containing methanol.
– Do Not store fuel either in the fuel tank or
fuel containers over the winter unless a fuel
stabilizer is used.
– Do Not add oil to gasoline.
• Fuel Filter: In fuel tank
• Fuel Shut-Off Valve: 1/4 turn
Electrical System (Electric Start)
• Charging System: Flywheel Alternator
• Charging Capacity: 16.7 amps
• Battery Type: BCI Group U1
• Battery Voltage: 12 Volt
• Polarity: Negative Ground
• Fuses:
– 20 amp main fuse
– 20 amp charging system fuse
Safety Interlock System
Engine will not start unless the park brake is engaged.
Operator Controls
Steering and Motion Control:
• Moving the steering control from side to side
controls right and left travel.
• One lever in the center of the steering control,
controls both drive wheels for moving forward or
reverse, stopping, and power turning.
• Motion control lever automatically returns to the
neutral position if released.
Transaxle
• Pump/Motor/Axleshaft with internal wet disc
brake
• Hydraulic Oil: Use Hydro Oil.
• Hydraulic Oil Capacity: 2.6 qt (2.5 L) plus
expansion reservoir .6 qt (.6 L)
Note: There should be approximately 1/4–1/2
inch (6.4–12.7 cm) oil in the reservoir.
• Speeds:
– 0-5.5 mph (9 km/hr) forward.
– 0-4.0 mph (6 km/hr) reverse.
• Drive wheel release valve allows machine to be
moved when engine is not running.
Wheel Drive System
Drive wheels are direct mounted to transaxle on 1
inch (25.4 mm) double–D shaft.
11
Specifications