Exmark Z Turf Equipment Z-SPRAY Operator's Manual page 26

Operation
the machine and cause a loss of control. Follow
directions for counter weights.
• If you lose control of the machine, step off and
away from the direction of travel of the machine.
Open the Fuel Shut-Off Valve
Rotate the valve clockwise to open.
Starting the Engine
1. Ensure the motion control lever is in the neutral
position.
2. Push downward on the parking brake lever to
engage the parking brake.
3. Place the throttle midway between the "SLOW"
and "FAST" positions.
4. On a cold engine, pull the choke knob upward
into the "ON" position.
On a warm engine, leave the choke pushed down
in the "OFF" position.
5. Turn ignition switch to the "START" position.
Release the switch as soon as the engine starts.
Important: Do Not crank the engine
continuously for more than ten seconds at a
time. If the engine does not start, allow a 60
second cool-down period between starting
attempts. Failure to follow these guidelines
can burn out the starter motor.
6. If the choke is in the "ON" position, gradually
return choke to the "OFF" position as the engine
warms up.
Driving the Machine
CAUTION
Machine can turn rapidly by moving the steering
control to the far right or left. Operator may
lose control of the machine, which may cause
damage to the machine or injury.
• Use caution when making turns.
• Slow the machine down before making sharp
turns.
Important: To begin movement (forward or
backward), the brake lever must be disengaged
(pulled up) before the motion control lever can
be moved.
Driving Forward
1. Make sure the motion control lever is in the
neutral position.
2. Release the parking brake.
3. To move forward in a straight line, place the
steering control in the center and move the
motion control lever forward.
To turn left or right, move the steering control
toward the desired turn direction.
The machine will move faster the farther the
motion control lever is moved from the neutral
position.
4. To stop, position the motion control lever in
the neutral position; releasing the lever will
automatically return it to neutral.
Note: Stopping distance may vary depending on
the spreader-sprayer load.
Driving in Reverse
1. Move the motion control lever to the neutral
position.
2. To move rearward in a straight line, slowly move
the motion control lever rearward.
26
Figure 13
g020125