Exmark Z Turf Equipment Z-SPRAY Operator's Manual page 19

Granular Impeller Speed Control
Located at the lower right side of the control console
(see Figure 5).
Push the rocker switch quickly to turn the granular
impeller motor "ON".
Push and hold the button down to turn "OFF".
Toggle switch up to increase the impeller speed or
toggle switch down to decrease speed.
Spray Pump/Tank Agitation Pump
Switch
Located to the left of the granular impeller
"ON"/"OFF" switch and display (see Figure 5).
Push the button up to turn the pump on. Push the
button down and hold to turn off.
Spray Wand Flow Valve
Located on the right side of the control console (see
Figure 5).
Rotate the knob counterclockwise to increase the
spray system flow or clockwise to decrease flow and
shut it off.
Spray Pressure Display
The spray pressure display shows the fluid pressure
in the spray system.
Spray Pressure Control
Located to the right of the spray pressure display (see
Figure 5).
Tap the control clockwise to increase pressure and
down to decrease. Hold down to turn off.
Spray Wand Trigger
Located on the bottom of the spray wand handle.
Squeeze the trigger to the handle of the spray wand
to allow spray; release the trigger to stop.
1. Trigger
2. Trigger lock
Spray Wand Trigger Lock
Located on the bottom of the spray gun handle (see
Figure 10).
When the trigger is squeezed and held against the
handle of the spray gun, push the lock trigger to keep
it in the open flow position. Push the lock again to
release the trigger.
Tank Drain Valve
Located on the left side under the spray tank.
Rotate valve handle clockwise 90 degrees to
open (lever inline with valve). Rotate 90 degrees
counterclockwise to close.
Spray Pump Supply Valve
Located on the right side under the spray tank.
Rotate valve handle counterclockwise 90 degrees
to open (lever inline with valve). Rotate 90 degrees
clockwise to close.
Rate Gate Dial and Linkage
Located at the front of the machine below the
spreader hopper.
The rate gate dial and linkage is used to set the
amount of material to be dispensed from the granular
gate (see Figure 11).
19
Operation
Figure 10
3. Spray wand handle
g033338