Advertisement
NCA-2513 User Manual
2. Place the disk drive in the tray, as shown in the image below. Apply two disk screws with two
rubber washers for each side of the disk drive. If you are going to install two disks, always
start by installing the disk in the lower slot.
3. Place the tray with HDD/SSD installed back to its original spot inside the system. Remember
to aim at the four latching holes. Then slide the tray upwards to get it locked and secure it
with the original screw.
4. Attach the SATA cables to the disks, and insert the cable ends into the corresponding
connectors on Motherboard.
JSATA1
JSATA2
32
Advertisement
