Assigning A Radio Keypad To Partitions - Cooper Security i-on Series Engineering Manual

Step by Step Programming Procedures
9. Press .
The bottom line of the display shows the
keypad's current name. The cursor is on the first
character on the left.
10. See page 18 for hints on how to edit names.
11. Press  to save the text.
12. Carry on with any other programming that you
need to do. DON'T FORGET to leave the Installer
Menu in order to save the changes you have
made (see page 12 ).

Assigning a Radio Keypad to Partitions

30 40 50 160
The control unit allows you to assign radio keypads to one or more of the
partitions.
Note: If you selected "Part set mode" during Initial Power-up then you cannot
assign a radio keypad to a partition (see System Options–Restore Defaults–
Factory Defaults on page 90 if you want to change the system from Part
Setting to Partitions).
1. Enter Installer Menu.
2. Press .
3. Press  until the display shows:
4. Press .
5. Press .
6. Press .
The bottom line of the display shows the first in
a list of the radio keypads that have been
learned by the control unit.
7. Press  or  to select the keypad that you wish
to name.
8. Press .
The bottom line of the display shows ―Name‖.
Page 152
i-on Range





















