Advertisement
OPERATION FOR MODE 1, DIP switch #1 OFF
The key chain transmitter has six buttons. They are labeled with roman numerals I, II,
III, IV, V, and VI. The red light next to the programming switches will flash once briefly each
time a button is pressed to verify the command has been received.
Button I controls the driver's window. The first time it is pressed it will roll the window
down until the button is released. The next time it is pressed it will roll the driver's window up
until it is released. Button II controls the passenger's window. It works the same as button I,
reversing the window direction each time it is pressed.
Button III releases the driver's door latch. It will send 12 volts to the actuator for about
one second. The relay is turned off automatically to prevent burning out the latch release
actuator. Button IV releases the passenger's door latch. It will send 12 volts for approximately
one second. The "flash" output on the white/black wire will be activated for about ½ second
each time a latch output is activated. This can be used to disable an alarm system or
connected to a relay to flash parking lights.
Button V Trunk latch application: Pressing button V will activate the third internal relay
for about one second. The white w/blue and white w/red wires should not be used.
Button V Trunk lift, lock/unlock, or similar: The first time the button is pressed it will
raise the trunk (or unlock doors) until it is released. The next time it is pressed it will lower the
trunk, (or lock doors) until it is released. The purple wire should not be used.
Button VI will activate an auxiliary relay which can be used to operate almost any
accessory. When DIP switch #2 is off: the first time the button is pressed it will activate Aux 1
output until it is released, the next time it is pressed it will activate Aux 2 output until it is
released. When DIP switch #2 is on, the Aux 1 relay output will turn on and remain on the first
time the button is pressed. The next time the button is pressed the relay will turn off.
When the ignition key is on, the only buttons that will work are I and II (VI will also work
if switch #2 is on). Buttons III, IV, V, and VI are disabled. This safety feature will not allow the
doors or trunk to accidentally release while the vehicle is in motion. This disables the key
chain transmitter only. The emergency release switch will not be disabled.
Drv. wind up/down
Drv. door latch
Trunk up/down
Trunk latch
Pass. wind up/down
Pass. door latch
Aux. 1/Aux. 2
9
Advertisement
