Advertisement
POWER WINDOW WIRING
Power window regulators are not included with the remote system base kit. They are
available separately from Dakota Digital. This remote system is designed to wire into existing
power windows or installed at the same time as power windows are added to the vehicle. Use
the diagram which matches the way your power windows are connected. The relays are
designed to duplicate the function of the power window switch you are using.
Because the switch pin-out varies with different switch types and between different
manufacturers, refer to your power window wiring instructions for window regulator and switch
color code and pin location. The diagram below shows how to hook up the remote system to
an existing power window harness. It is recommended that the power windows be first wired
up to its own switches and wiring harness without the remote system. Once the power
windows are working correctly with the supplied switches, then connect the remote system
relay packs up to the harness. This will simplify correcting any wiring problems that may show
up.
REGULATOR AND SWITCH
NOT INCLUDED
WHITE
BLACK
GROUND-AT-REST
Switch - contact
positions vary
with style
+12V
GND
WHITE
GND
BLACK
Figure 4. Connection to Specialty, Downs, Balls, GM, and other power window regulators
This wiring diagram can be used with most power window and switch combinations.
The existing switch (or in some cases relays) keep the two wires to the motor grounded when
the window is at rest. To move the window up, the "up" wire is switched to 12 volts while the
"down" wire remains grounded. To move the window down, the opposite occurs. For both the
existing switch and the remote system to be able to move the window, the wires between the
switch and the window regulator need to be cut and separated. These wires are then
connected to the supplied dual relay pack. One relay in the pack will roll the window up, the
other down.
While the remote system itself should not be mounted in the door, the relays can be.
Mount them so the wires are going out the bottom. This will prevent water from catching in it.
The wiring for the passenger side is identical to the driver's side.
WIRE COLORS COMING FROM
WINDOW REGULATOR MAY
VARY DEPENDING ON
MANUFACTURER.
CONSTANT-ON
FUSED +12V
PURPLE
TO CONSTANT-ON
FUSED 12V
WHITE TO MOTOR
BLUE
BLACK TO MOTOR
GREEN
WHITE TO SWITCH
BROWN
BLACK TO SWITCH
WHITE
using a 5-wire or center-position grounding switch.
RED
BLACK
CHASSIS
GROUND
BLUE
WHITE
small wire
DUAL
RELAY
RED
CONSTANT-ON
PACK
FUSED 12V
GREEN
GRAY
small wire
4
Driver's Window
Emergency Entry
Switch
BROWN
SEALED
SWITCH
GROUND
PURPLE
BLUE
small
BLUE
ORANGE
wire
DUAL
RELAY
RED
GREEN
PACK
BROWN
PINK
GREEN
WHITE
small
wire
Advertisement
