Advertisement
Drv. wind up/down
OPERATION FOR MODE 2, DIP switch #1 ON
The key chain transmitter has six buttons. They are labeled with roman numerals I, II,
III, IV, V, and VI. The red light next to the programming switches will flash once briefly each
time a button is pressed to verify the command has been received.
Button I controls the driver's window. The first time it is pressed it will roll the window
down until the button is released. The next time it is pressed it will roll the driver's window up
until it is released. Button II controls the passenger's window. It works the same as button I,
reversing the window direction each time it is pressed.
Button III releases the driver's door latch. It will send 12 volts to the actuator for about
one second. The relay is turned off automatically to prevent burning out the latch release
actuator. Button IV releases the passenger's door latch. It will send 12 volts for approximately
one second. Button V will activate the trunk latch. It send 12 volts for approximately one
second. The "flash" output on the white/black wire will be activated for about ½ second each
time a latch output is activated. This can be used to disable an alarm system or connected to
a relay to flash parking lights.
Button VI activates the alternate functions for each button. Press and release button VI
and then press one of the other buttons for the functions listed below.
Pressing button VI, and then button I will activate an external relay to raise a trunk lift,
unlock doors, or any other function. It will remain on until the button is released.
Pressing button VI, and then button II will activate an external relay to lower a trunk lift,
lock doors, or any other function. It will remain on until the button is released.
Pressing button VI, and then button III will operate Aux. 1. If DIP switch #2 is off then it
will turn on and remain on until the button is released. If DIP switch #2 is on then it will latch
the output on the first time it is activated and latch the output off the second time it is activated.
Pressing button VI, and then button IV will operate Aux. 2. If DIP switch #2 is off then it
will turn on and remain on until the button is released. If DIP switch #2 is on then it will latch
the output on the first time it is activated and latch the output off the second time it is activated.
When the ignition key is on, the only buttons that will work are I and II (Aux1 & Aux2 will
also work if switch #2 is on). Buttons III, IV, V, and VI are disabled. This safety feature will not
allow the doors or trunk to accidentally release while the vehicle is in motion. This disables the
key chain transmitter only. The emergency release switch will not be disabled.
(Trunk up)
Drv. door latch
(Aux 1 output)
Trunk latch
Pass. wind up/down
(Trunk down)
Pass. door latch
(Aux 2 output)
Activate alternate function
shown in ( )
10
Advertisement
