Advertisement
INSTALLATION
The receiver should be mounted on the interior of the vehicle so that it is not exposed to
moisture. It can be secured using the four mounting holes or with a double sided adhesive
tape, such as Velcro. The main harness plugs into one end of the unit with a 16 pin connector
and the antenna plugs into the other end with a 3 pin connector. The antenna should be
mounted away from any power wires or motors.
The color code for the main harness is listed below. The unit only needs the red and
black wires connected to operate. The others should be hooked up according to your
application. The CMD-10k should only be connected to a 12 volt battery for power and never
solely to a battery charger.
RED
BLACK
YELLOW
BROWN
BLUE
GREEN
PURPLE
WHITE/RED
WHITE/BLUE
ORANGE
PINK
WHITE
GRAY
WHITE/GREEN
WHITE/VIOLET
WHITE/BLACK
The blue, green, and purple wires are connected to internal relays and can feed 12 volts
out at up to 10 amps for the full pulse duration, 15 amps briefly. They are protected by an
internal, self-resetting circuit breaker. The white, gray, orange, pink, white w/ green strip, white
w/ violet strip, white w/ black strip, white w/ red strip, and white w/ blue strip are negative
switched outputs designed to only turn on external relays. This combination of internal and
external relays was used to reduce the number of wires going through the door jams to a
minimum. To eliminate having any wires running through your door jams, use DAKOTA
DIGITAL MAGNUM SHOOTERS. Refer to the following diagrams for connection to your
particular actuators and power windows.
door
jamb
use a flexible rubber tube
to protect the wires.
Wiring through door jamb
constant 12 volt battery source
chassis ground
ignition key switched 12 volts
driver's window emergency switch
driver's door latch actuator
passenger's door latch actuator
trunk release latch actuator
trunk lift motor raise relay
trunk lift motor lower relay
passenger's window up relay
passenger's window down relay
driver's window up relay
driver's window down relay
auxiliary relay output 1
auxiliary relay output 2
"flash" output (parking light flash or alarm system disable)
door
allow slack for door to open fully
door
door
jamb
Using MAGNUM SHOOTERS!
2
Advertisement
