Programming; Selection Screens; Option List Screens; Data Screens - Badger Meter Impeller Data Industrial 3050 Series User Manual

PROGRAMMING

With the normal mode display showing, press Menu to enter the programming mode . In this mode, you use the three arrow
keys () on the selection screens to select the option displayed above the key, and on the option list screens to scroll up
or down a list of choices, like a pull-down menu . Most screens presenting choices show three choices, one for each arrow key .
When the number of choices exceeds three, a small arrow () appears on the upper right of the display, indicating there are
more choices on that level . Press Enter to toggle to the next set of choices . Once the selection has been made, press Enter to
complete the selection . Press Menu again to return to the normal mode display .

Selection Screens

Most selection screens show three choices, one for each arrow () key . When the number of choices exceeds three, a
small arrow (  ) appears on the upper right side of the display, indicating there are more choices on that level . Press Enter to
view the next set of choices .
For example, pressing Menu from the normal mode screen shows the RESET SETUP DIAG screen . Pressing the Up Arrow key
brings up the RESET screens . Pressing the Down Arrow key brings up the SETUP screens and pressing the Right-Arrow key
brings up the DIAG (diagnostic) screens . In this example, if you press the Down Arrow key, this screen appears:

Option List Screens

Units of measure is an example of an options list screen .
Press the Up Arrow key to scroll up the list or press the Down Arrow key to scroll down the list . In this case, the list starts with
GPM; gal/s; gal/hr;...LPM;.... and ends with Custom Units .
With a selection highlighted, press Enter to complete the selection or press Menu to leave the selection unchanged . The
Right-Arrow key has no function on this type of screen .

Data Screens

Some screens are data entry screens . For example, the Setpoint or Custom Unit screens .
When a data entry screen is active, the current value displays . The left-most digit flashes . Press the Up Arrow key to increase
the value . Press the Down Arrow key to reduce the value . If the decimal point is flashing, press the Up Arrow key to move the
decimal point to the right or press the Down Arrow key to move the decimal point to the left .
June 2018
SETUP
PWORD DSPY FLOW1
Menu Enter
Figure 19: Selection screen
Flow 1 units
GPM
Menu Enter
Figure 20: Option list screen
Setpoint
1.00000000
Menu Enter
Figure 21: Data screen
DSY-UM-01668-EN-02
Programming
Page 17