Display And Keypad - Badger Meter Impeller Data Industrial 3050 Series User Manual

Display and Keypad

DISPLAY AND KEYPAD
The Series 3050 BTU flow monitor has a two line by 16-character display with two modes of operation and 5 keys on the front
panel for programming .
Menu 1-Switch to main menu
2-Backward/Previous menu
Enter 1-Save value
2-Forward/Next menu
When the Series 3050 BTU flow monitor is first powered up, it runs through internal self checks while displaying
"Badger Meter DIC Initializing." At the end of this cycle its normal mode display will appear .
In the normal mode, if still using the factory defaults, flow rate will be displayed on the top line, and flow total displayed on
the bottom . Both lines can be custom-defined in the field as desired . In the normal mode the Enter key has no function .
The other mode is the program mode, used to configure the unit . Press Menu to enter and exit this mode . See
on page 17 .
Page 16
Up Arrow 1-Select Menu option
2-Increase numerical value
Down 1-Select Menu option
Arrow
2-Decrease numerical value
Right 1-Select Menu option
Arrow
2-Move cursor to the right
0.0 GPM
0.0 gal
Menu Enter
Figure 17: Normal mode display
RESET SETUP DIAG
Menu Enter
Figure 18: Program mode display
DSY-UM-01668-EN-02
"Programming"
June 2018