Electrical Installation; Power Supply Wiring - Badger Meter Impeller Data Industrial 3050 Series User Manual

Installation

Electrical Installation

Power Supply Wiring

The Series 3050 BTU flow monitor requires 12...24 V DC/AC to operate . Check the
draw and AC Volt-Amp requirements .
Always use a fused circuit .
Connect the positive of the power supply to the flow monitor terminal marked (ACL/DC+), and connect the negative of the
power supply to the flow monitor terminal marked (ACC/DC-) .
If a Badger Meter plugin power supply (Model A-1028) is being used, connect the black-white wire to the terminal marked
(ACL/DC+) and the black wire to the terminal marked (ACC/DC-) .
Page 8
Earth 3
POWER LV AC/DC (-) 2
LV AC/DC (+) 1
Figure 4: Power supply wiring
DSY-UM-01668-EN-02
"Specifications" on page 30
Ground wire should be heavy gauge and as short as possible.
(+) (-)
(Line) (Com)
or
12 . . . 24V DC
12 . . . 24V AC
Power
Power
Supply
Supply
for DC current
Earth
or
Panel
Ground
June 2018