Keypad/Display Menu Navigation - Badger Meter Data Industrial 3100 Series User Manual

Keypad/Display Menu Navigation

The Series 3100 flow monitor has a two line by 16-character display with two modes of operation and 5 keys on the front
panel for programming . Two of the keys (Menu and Enter) serve a single function while the three remaining keys ()
serve dual purposes .
When the flow monitor is first powered up, it performs internal testing while displaying "Badger Meter DIC Initializing . " At the
end of the internal testing cycle, the main display appears .
In the normal mode, using the factory defaults, the flow rate displays on the top line and the flow total displays on the
bottom . Both lines can be custom defined in the field . In the normal mode, ENTER has no function .
1
1 123456.7 gal
Flow Channel 1 Flow Rate and Flow Total Flow Channel 1 Flow Rate and Flow Total
2
1
Channel 2: Pressure and Channel 1: Level
Channel 2: Pressure and Channel 1: Level
SETUP
PWORD DSPY FLOW1
As seen in the previous figure, on every screen there are Three
Choices, and three corresponding buttons. However, on this menu
On every screen there are three choices and three
"Set-up" there are more choices than fit on the screen. The is
indicated by the " →". To access these remaining choices press the
"Enter" Button.
corresponding buttons . However, on this Setup menu there
are more options than fit on the screen . The arrow ()
indicates additional options . To access these remaining
options, press ENTER .
October 2017
123.00 GPM
10.01 PSI
23.09 Feet
→
Flow Channel 1 Flow Rate and Flow Channel 2 Rate
Main Setup screen accessed by pressing MENU.
On each screen there are three options:
selects RESET  selects SETUP and  selects DIAG
Press ENTER again to bring up the next set of choices .
Press MENU to exit an option, or return to the previous
screen, or—in some cases—to return to the main
CTL-UM-01026-EN-05
1 123.00 GPM
2 123456.70 GPM
Flow Channel 1 Flow Rate and Flow Channel 2 Rate
RESET SETUP DIAG
Main Set-up screen accessed by pressing the "MENU" Button
One each screen there are three Choices
(In this case RESET SETUP and DIAG)
▲ selects RESET ▼ selects SETUP and ► selects DIAG
→
SETUP
FLOW1 RLY1 RLY2
Pressing the "Enter" button again brings up the next set of choices,
and so on.
Pressing "MENU" button exits section, back to the previous
screen, or in some cases back to the Main display screen.
display screen .
Installation
Page 13