Installation & Operation; Installation Instructions - FRIGOGLASS Plus-450 User Manual

3. Installation & operation
3.1

Installation instructions

i. After unpacking, check the cabinet for any damage caused during transportation. In the event of
damage, please contact the forwarding company.
ii. Always ensure that your merchandiser is installed on a stable surface/floor. There are 2
adjustable feet at the front, under the chassis. The cooler must be leveled through proper
adjustment of the leveling feet in all installations. It must be ensured that the cooler does not
exhibit any inclination towards its front side and/or its lateral sides, after adjustment. A slight
inclination toward its back side will further facilitate the good circulation of the fluid and support
the door closing mechanism. The use of a spirit level is highly advisable to check leveling. Verify
that the cooler sits firmly on the leveling feet. The front cooler wheels (if available) should be
able to rotate by hand after cooler installation and adjustment.
Mains connection: if the mains cord supplied is not long enough, do not use an extension lead
and do not replace it. Ask an authorized electrician to replace the cord with a longer one.
iii. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This gives the oil time to run back to the compressor after transit and installation.
Failure to comply with the instructions may result in high-energy
consumption, poor performance of the unit and void warranty.
Do not place the merchandiser:

in direct sunlight or near heat sources (radiators, stoves & other
heating equipment)

outdoors, without proper protection from rain, moisture and other
atmospheric elements

in weather conditions for which it is not certified

in extreme environmental conditions (i.e. extensive exposure to
saline humidity)
•
Keep clear of obstruction all ventilation openings in the appliance
enclosure or in the structure for building-in.
•
Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the
manufacturer.
•
Do not damage the refrigerant circuit.
•
Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
•
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
ENG
2