1. Foreword Thank you for purchasing this new Ice Cold Merchandiser (ICM) from Frigoglass. Before using this unit please read the instructions below carefully. We want you to enjoy the benefits of this cooler with trouble-free operation for many years. A well-maintained Frigoglass ICM will help you increase your sales and profits.
3.1 Installation instructions Always ensure that your merchandiser is installed on level floor. There are 2 adjustable feet at the front and back under the chassis. Please adjust until the ICM levels. Check by using a spirit, if available. Do not install the merchandiser under direct sunlight or near heat sources Install a 38mm spacer behind the unit to ensure a gap behind the unit for proper air circulation.
3.3 Connection to the mains supply Connect the ICM to a 230V, 50Hz power supply on a min 10A fused & grounded socket. Do not use extension cables. If the power cord is not long enough, either install a new socket nearby or ask an authorized electrician to replace the cord with a longer one.
There are 4 LED tube lights in the ICM. One is located in the middle of the canopy and two inside the cabin; one at the side and the other at the top. To replace the fluorescent tube, do the following: For the middle light inside the cabin: •...
Page 8
FAULT POSSIBLE REASONS HANDLING Power cord not plugged in. Plug it in. The ICM does No power coming through not work. Check for fuse on the mains the socket. Lower the set point as follows: Press the "set" button, then keep the “down"...
FAULT POSSIBLE REASONS HANDLING This feature is designed to The door has been left open. reduce the ambient air ingress while opening the door. Evaporator fan This feature is designed to Energy-saving mode during is not running save energy during the the compressor off cycle.
Need help?
Do you have a question about the CL 950 and is the answer not in the manual?
Questions and answers