Table of Contents
Advertisement
5.
SATA Power header (4-pin SATA_PWR)
This header is for the SATA power cable. The power cable plug is designed
to fit this header in only one orientation. Find the proper orientation and push
down firmly until the header completely fit.
IMPORTANT: The SATA Power header supports 1A current to the maximum.
6.
SATA 6.0Gb/s connectors (7-pin SATA6G_1~2)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
IMPORTANT: When using hot-plug and NCQ, set the SATA Mode Selection
item in the BIOS to [AHCI]. See section 3.3.3 SATA Configuration for details.
2-20
SATA_PWR1
+12V
GND
GND
+5V
SATA6G_1
A
RSATA_RXP
RSATA_RXN
B
SATA6G_2
RSATA_TXN
RSATA_TXP
GND
GND
GND
MIX-Q370D2
Advertisement
Table of Contents
