Dp-V1 - I&M Data - YASKAWA VIPA System 300S Manual

Chapter 3 Deployment
DP-V1 - I&M data
Overview
Structure
I&M data
Identification data 0: IM_INDEX: 65000
MANUFACTURER_ID
ORDER_ID
SERIAL_NUMBER
HARDWARE_REVISION
3-16
Identification and maintenance data (I&M) are stored information in a
module which support you at:
• check of the system configuration
• discover of hardware changes
• remove errors in a system
Identification data (I data) are information of the module e.g. order number,
serial number, which can be found printed at the module.
I data are manufacturer information and can only be read.
Maintenance data (M data) are information like location and date of
installation. M data were produced and stored during project engineering
By means of I&M data the modules can online be identified.
Note!
Only one DP master may access at one time the I&M data.
The data structure of the I&M data corresponds to the specifications of
PROFIBUS guideline - order no. 3.502, version 1.1 from May 2003.
Access
read (2byte)
read (20byte)
read (16byte)
read (2byte)
Preset Explanation
022Bh (555) Name of the manufacturer
(555 = VIPA GmbH)
depends on the Order number of the module
module VIPA 053-1DP00
depends on the Serial number of the module for
module clear identification.
depends on the Hardware revision of the module
module which is incremented on changes at
the firmware.
HB140E - IM - RE_353-1DP01 - Rev. 14/47
Manual VIPA System 300S
continued ...