Epson T3 Series Safety And Installation page 72

2. Installation
Manipulators are not suitable for operation in harsh environments such as painting
areas, etc. When using Manipulators in inadequate environments that do not meet
the above conditions, please contact the supplier of your region.
For the Protection-model Manipulator, be sure to install the robot system in an
environment that also meets the following conditions:
Environment
*1 The Manipulator body is mainly made of iron and aluminum. It is not rust-
proofed. Do not use the Manipulator under conditions where it can be exposed
to water or any other corrosive liquid (including water).
*2 Any contaminants that can deteriorate sealing performance of nitrile rubber oil
sealing, O-rings, packing seals and liquid gasket should be avoided.
Special Environmental Conditions
The protective seals are attached on the Protection model Manipulator to prevent
dust, water, etc. from the outside.
described below.
The surface of the Manipulator has general oil resistance.
requirements specify that the Manipulator must withstand certain kinds of oil, please
contact the supplier of your region.
Rapid change in temperature and humidity can cause condensation inside the
Manipulator.
If your requirements specify that the Manipulator handles food, please contact the
supplier of your region. to check whether the Manipulator will damage the food or
not.
The Manipulator cannot be used in corrosive environments where acid or alkaline
is used. In a salty environment where the rust is likely to gather, the Manipulator
is susceptible to rust.
When mounting Manipulator on the mobile platform, be sure to use mobile platform
in low acceleration. If using the mobile platform in high acceleration, it may cause
Manipulator to make a safety stop.
54
Item
- Install indoors.
- Keep away from direct sunlight.
- Keep away from salinity or other contaminants.
- Keep away from flammable or corrosive solvents
- Keep away from organic solvents, acids, alkalis,
- Do not use in water.
- Keep away from shock or vibration.
- Keep away from sources of electric noise.
- Available under the environment with dust, oily
Safety and Installation (T, VT / EPSON RC+ 7.0) Rev.15
Conditions
*1
(including water)
and chlorine cutting fluids.
*2
smoke, and metal
Follow the precautions in use environment
and gases.
.
However, if your