L3 FA2100 CVR Component Maintenance Manual With Illustrated Parts List page 282

1. GENERAL
This section provides the FA2100CVR recorder's specifications and outline and dimen-
sions. Since the recorder uses solid−state memory recording technology, there are no in-
ternal fits and clearances or tension values normally associated with older technology
electromechanical tape recorder units.
The information contained herein is also in the Description/Operation section of this CMM
and is presented here for the purpose of quick reference.
2. SYSTEM SPECIFICATIONS
The Model FA2100CVR meets the performance requirements of ED-56A, chapters 2, 3,
4, and 5, and 7, ED−112, chapter 2, and Part I, while conforming to the input interface
required in ARINC 557/757. When the software detects a fault an CVR FAULT will be as-
serted immediately with no artificial delay.
A. Physical Characteristics
(1) Size: (Refer to Figure 801. for the FA2100CVR Outline & Dimension Drawing)
Height:
Width:
Depth:
(2) Weight:
(3) Case:
(4) Main (Rear)
Connector:
(5) Main (Rear)
Mating Connector:
(6) Ground Support
Equipment Connector:
Use or disclosure of information on this sheet is subject
to the restrictions on the cover page of this document.
The document reference is online, please check the correspondence between the online documentation and the printed version.
AVIATION RECORDERS
COMPONENT MAINTENANCE MANUAL
FA2100CVR
FITS AND CLEARANCES
5.5 inches
4.98 inches
12.6 inches (behind front panel)
10.0 ($.5) pounds nominal
7.7 ($.5) pounds (p/ns: 2100−1010−51
and 2100−1020−51)
404A–ATR Case, Short. Stainless Steel
CSMU Housing, International Orange,
Reflective Striping, English/French
Markings
57–Pin Connector Compatible with
ARINC757, p/n: 063E1072–00 (Cannon
p/n: DPXBMA–36571–59)
Crimp: p/n: 063–98–01474 (Cannon p/n:
DPXBMA–57–33S- 0001)
Solder: p/n 9300–435 (Cannon p/n:
DPXB-57-33S-0001)
p/n: 063–98–01962 (AMP p/n: 748481–6)
23–70–04
Fits and Clearances
Rev. 15 Page 801
Apr. 14/16