L3 FA2100 CVR Component Maintenance Manual With Illustrated Parts List page 229

RECORDER USB FDAU
SIMULATOR (RUFS)
(RI) ADAPTER
17TES0076
RECORDER INTERFACE (RI)
CABLE ASSY.
17TES0057
AC
INPUT
DC
INPUT
Note: RI = Recorder Interface.
ROSE = Read‐Out Support Equipment.
ROC = Read‐Out Center (ROC/5, /6 or /7)
Note: The ROC rear connections shown in this diagram are for
general reference and may not reflect the exact connector
location or configuration your ROC system computer.
Note: The 17TES0058 cable assembly should only be attached
during upload process. Not used when downloading data
or getting recorder status.
Typical Software Upload Setup For FA2100 Recorder with CICC/2 Cable
Use or disclosure of information on this sheet is subject
to the restrictions on the cover page of this document.
The document reference is online, please check the correspondence between the online documentation and the printed version.
AVIATION RECORDERS
COMPONENT MAINTENANCE MANUAL
FA2100CVR
Power
Input
Select
READ-OUT CENTER/5, /6 or /7
17TES0300/17TES0400/17TES0700
Figure 177.
ROSE/RI SOFTWARE
17TES0321 (CDROM)
FA2100 SOFTWARE
DISTRIBUTION DISK
Note: Firmware Distribution
Diskette P/N will match the
FA2100 Software Part
TO
Number located on the
ENHANCED recorder 's Name Plate Label.
PARALLEL PORT
(EPP)
COMPUTER INTERFACE
COMMUNICATIONS CABLE/2
COMPUTER INTERFACE
COMMUNICATIONS CABLE
(BOOTLOAD) CABLE ASSEMBLY
FA2100 CVR
RECORDER
23–70–04
Testing & Fault Isolation
840‐EXXX‐XX
CICC/2
17TES0070
FA2100 TO CICC/2
17TES0072
FA2100
SOFTWARE UPLOAD
17TES0058
(use for software
uploading only)
Rev. 15 Page 180
Apr. 14/16