L3 FA2100 CVR Component Maintenance Manual With Illustrated Parts List page 258

1. GENERAL
This section contains procedures describing the assembly of the Model FA2100 Cockpit
Voice Recorder as well as storage instructions after assembly. There is no special testing
necessary during assembly. However, once assembly is completed, the operational test
procedure provided in the Testing and Troubleshooting Section 100 should be performed
to verify proper operation of the Recorder.
2. REQUIRED MATERIALS
Special equipment required for testing and assembly of the recorder can be found in
Table 901 of the Special Tools, Fixtures, and Equipment Section 900 of this CMM.
Table 701 provides a list of the common assembly materials used with the FA2100 Cock-
pit Voice Recorder.
Item
1.
Adhesive
2.
Torque Wrench
3.
RTV Adhesive
4.
Tape, Polymide MMM (3M) 5413
5.
Tool, Assembly
Support
6.
Tool,
Seal Align-
ment, Short Chassis
7.
Tool,
Seal
Applicator
Use or disclosure of information on this sheet is subject
to the restrictions on the cover page of this document.
The document reference is online, please check the correspondence between the online documentation and the printed version.
AVIATION RECORDERS
COMPONENT MAINTENANCE MANUAL
FA2100CVR
ASSEMBLY
Table 701. Required Assembly Materials
Manufacturing and Specification
Loctite, Grade E, Purple No. 222
Lock/sealant manufactured by Loctite Corp.,
705 N. Mountain Rd.,
Newington, CT 06111 [V05972]
Local tool supplier
Range: 5−6 in/lbs
End Range: 75 in/lbs
Dow Corning RTV 3145 (V71984)
L-3 p/n: 0601200006, or equivalent
L-3 p/n: 2529800034, or equivalent
L-3 p/n: 980E2196-00, or equivalent
L-3 p/n: , or equivalent
980E2188-00
L-3 p/n: , or equivalent
980E2189-00
Use
Retain screw
CSMU & Beacon Brack-
et mounting screws
(75 in/lbs.); Chassis
Cover screws (9-10 in/
lbs; and Rear Panel &
AP board screws (5-6 in/
lbs.)
Chassis
Chassis
Audio Compressor PWA
Installation
Chassis Seal
Installation
Chassis Seal
Installation
23–70–04
Assembly
Rev. 15 Page 701
Apr. 14/16