Bosch LTC 8900 Series Installation Manual page 64

64 en | Satellite System Configuration Installations
camera number lines in the table may be reserved at this time for future expansion. If a local
title is specified, the camera's title can also be entered at this time. Designate any local
camera numbers appropriately, and enter their corresponding titles.
Figure 8.7: Main Site Sample Program Showing Local Cameras, Trunk Lines and Remote Cameras
NOTE: Either a local camera, or a remote camera programmed with a local title, will need to
be selected to view certain on-screen prompts or data during programming of the main site via
a system keyboard.
Once the system is programmed and configured, any unused monitor outputs located at the
main site should be selected to display a local camera via the system keyboard. This prevents
unused monitor outputs from using up trunk lines which may result in some confusing
operational responses.
The "Start-up" camera numbers listed in the Monitor Table of the LTC 8059/00 software
should be programmed to specify locally connected cameras or a local unused input (i.e., the
raster generator will be displayed when called up). This table defines the camera numbers
that will automatically be switched to an operator's monitor in the event the trunk line being
used to display their original satellite camera is 'stolen' by an operator with a higher priority.
2015.01 | 10.6 | Installation Manual
LTC 8900 Series
Bosch Security Systems, Inc.