Module Insertion - Bosch LTC 8900 Series Installation Manual

en | Hardware Installation Procedure for Redundant System Configuration Utilizing LTC
40
8901 Series CPU
Install the power supply in the far right position of the bay, ensuring proper alignment and
seating of the supply into the rear mating connector. Verify that the power supply ON/OFF
switch is in the OFF position.
Figure 6.7: Typical Power Supply Insertion
Install 4 supplied screws and star washers on the rear panel of the bay(s) surrounding the
power supply line cord. This fastens the power supply securely in place. Repeat this
procedure for all LTC 8902 Series and LTC 8903 Series bays.
Caution!
If the LTC 8902 Series or LTC 8903 Series bays are to be transported, the main power
!
supplies should be removed to prevent possible damage to the bays internal parts.
Install the matrix bays into the mounting rack. Place the bays in the racks as described in
General Installation Considerations within this manual. Note, rack-mounting screws and
associated hardware are NOT included. Attach AC line cord, but do not power up the bay until
instructed to do so.
NOTE: The LTC 8902 Series and LTC 8903 Series bays should be installed so there is at
least 4.5 cm (1-3/4 in.) of clearance above and below the bay, to allow for proper cooling.
Failure to provide proper clearance may cause the equipment to exceed its recommended
operating temperature range.
DO NOT install the LTC 8934/00 Video Output modules or the LTC 8921/00 Video Input
modules into the matrix bays at this time.
6.6

Module Insertion

A special tool is supplied with the system components, for insertion of the Data Receiver,
Video Input Module, and Video Output Module boards into LTC 8902/90 and LTC 8903/90
equipment bays. The tool is a simple lever (an angled piece of aluminum), used as follows:
Insert the board fully into the slot, ensuring proper alignment with the connectors.
Insert the short end of the lever into the groove in the front of the bay so the tool is aligned
with the card ejectors on the card, then push the lever to force the card into the slot.
2015.01 | 10.6 | Installation Manual
LTC 8900 Series
Bosch Security Systems, Inc.