Table of Contents
Advertisement
7 Install the upper and lower mounting fixtures.
Place the upper mounting fixture on the top covers of the existing and expansion racks, and temporarily secure it with M12
hexagon bolts.
Using the M6 core spring nuts installed on the front and rear H frames of the racks in steps 3 and 5, secure the lower mounting
fixture with M6 flat head screws.
Fully tighten the M12 hexagon bolts that were temporarily tightened in the upper mounting fixture.
8 Mount the side cover on the expansion rack.
Mount the side cover, which was removed from the existing rack, with the 10 side cover retaining screws, which were also
removed from the existing rack.
Note: The weight of the side cover is about 15 kg. Be careful when mounting it.
9 Mount the front doors of the existing and expansion racks.
Lastly, mount the front doors to complete the rack connection procedure.
4 Handling the Rack after Installation
4.1 Changing the Position of the Door Rotation Axis
The position of the door rotation axis can be changed from the position at shipment. At the time of shipment, the front door
turns on the right axis. The rear door rack is a double door, so the positions of its rotation axes cannot be changed.
Changing the position of the rotation axis involves the repetitive action of removing parts and reinstalling them at different
locations. Work carefully to avoid causing deformation, breakage, or loss of parts during the removal and reinstallation of
parts.
4.1.1 Changing the position of the rotation axis of the front door
1 Changing the position of the rotation axis of the front door.
Open the door by 90 degrees. Lift up the door to remove the door-side hinges (pins) from the rack-side hinges, and then slide
the door sideways to remove it.
Note: When installing or removing the door, be careful not to get your fingers caught in the gap between the door and the rack.
38
Advertisement
Chapters
Table of Contents
