Installation And Lubrication; Parts And Maintenance - Ingersoll-Rand 5980 Series Product Information

Air impact wrench

Hide thumbs Also See for 5980 Series:

Table of Contents

Available languages

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain

condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a

properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose

coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling

disconnects. See drawing 16606964 and table on page 2. Maintenance frequency is shown in a

circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as :

1. Air filter

2. Regulator

3. Lubricator

4. Emergency shut-off valve

5. Hose diameter

When the life of the tool has expired, it is recommended that the tool be disassembled,

degreased and parts be separated by material so that they can be recycled.

Original instructions are in English. Other languages are a translation of the original instructions.

Tool repair and maintenance should only be carried out by an authorized Service Center.

Refer all communications to the nearest Ingersoll Rand Office or Distributor.

EN-2

Thread size

Coupling

Safety Air Fuse

Oil

10. Grease - through fitting

03532124_ed9

Table of Contents

Show Quick Links

Table of Contents

5982 series