Summary of Contents for Ingersoll-Rand 5980 Series
Page 1
16606048 Edition 1 November 2007 Air Impact Wrench Series 5980 and 5982 Maintenance Information Save These Instructions...
Page 2
WARNING Always wear eye protection when operating or performing maintenance on this tool. Always turn off the air supply and disconnect the air supply hose before installing, removing or adjusting any accessory on this tool or before performing any maintenance on this tool. Note: When reading the instructions, refer to exploded diagrams in parts Information Manuals when applicable (see under Related Documentation for form numbers).
3. Insert notched foot of Throttle Lever through slotted side of NOTICE Throttle Lever Spacer so end of foot hooks over top edge of Spacer. Make certain the Cylinder is properly installed. 4. Install a new Throttle Valve Face (57) on Throttle Valve (56). 5.
Place End Plate Gasket (11) on face of Rear End Plate. 9. Install assembled impact mechanism as follows: Install Backhead (12) on rear face of Motor Housing. Tighten With Impact Wrench positioned as it was in Step 8 (a), place a Backhead Cap Screws (14) to 75 to 90 ft-lb (102 to 122 Nm) Housing Cover Gasket on face of Motor Housing Cover (39).