Battery Installation, Life, And Status - Fluke SimpliFiber Pro Instruction Sheet

C
M
: Switches between continuous wave and 2 kHz modulated
output signals.
• Use continuous wave mode (
making loss or power measurements with a meter other
than a SimpliFiber Pro meter.
• Use the 2 kHz modulated output mode (
blinking) if locating fibers with a meter other than a
SimpliFiber Pro meter.
Also enables or disables auto power-off. See "Auto Power-
Off".
D
I
: Selects FindFiber mode, which is used with a SimpliFiber
Pro meter to help you quickly identify link connections at
patch panels. The ID 2 LED lights if the source is in FindFiber
mode.
E
The LOW BATTERY LED blinks continuously if the battery is
low. The LED blinks occasionally if auto power-off is disabled.
See "Auto Power-Off".
F
Output port with SC adapter.

Battery Installation, Life, and Status

Note: Fluke Networks recommends alkaline batteries.
•
The batteries last for about 30 hours of typical use. See the
specifications.
•
Replace the batteries if the LOW BATTERY LED blinks
continuously. The LED blinks occasionally if auto power-off is
disabled. See "Auto Power-Off".
LED on steady) for
CW/2 kHz
CW/2 kHz
AA
IEC LR6
NEDA 15A
LED
fft02.eps