SMC Networks PME-500-TR Quick Start Manual

SMC Networks PME-500-TR Quick Start Manual

Basic performance test
Hide thumbs Also See for PME-500-TR:

Advertisement

PME-500-TR basic performance test
nd
October 2
, 2009
PME-500-TR
Basic Performance Test
An EuroSMC
training paper
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PME-500-TR and is the answer not in the manual?

Questions and answers

Summary of Contents for SMC Networks PME-500-TR

  • Page 1 PME-500-TR basic performance test October 2 , 2009 PME-500-TR Basic Performance Test An EuroSMC training paper ®...
  • Page 2 These ‘switches’ are sensitive to polarity, and can be operated manually by pressing the ‘open’ or ‘close’ buttons in the PME-500-TR’s TEST menu. To check the coil control system for proper operation, you will need a small lamp, a suitable battery, a short section of conductor and a few simple steps: 1.
  • Page 3 1. Ensure that the PME-500-TR’s battery holds some charge or leave the unit switched off and connected to an AC outlet to re-charge for at least 15 minutes. This test takes the power from the battery, even if the unit is connected to a mains AC outlet.
  • Page 4 A2 in step 13. NOTE Restore your normal settings and check the unit’s date/time for proper adjustment before putting the PME-500-TR back into the transport bag *** END OF THE DOCUMENT *** ©EuroSMC, S.A. 2005 – PME-500-TR Basic Performance Test Procedures...

Table of Contents