Engine Oil; Cleaning Engine Oil Strainer - Sym Jet 4 125 Manual

SYM 3. LUBRICATION SYSTEM

ENGINE OIL

Turn off engine, and park the motorcycle in
flat ground with main stand.
Check oil level with oil dipstick after 3-5
minutes.
Do not rotate the dipstick into engine as
checking.
If oil level is nearly low level, fill out
recommended oil to upper level.
Dipstick
Oil Replacement
Oil drain plug
Caution
Drain oil as engine warmed up so that
make sure oil can be drained smoothly and
completely.
Place an oil pan under the motorcycle, and
remove oil strainer cap.
Make sure if the aluminum washer of the
draining bolt is damaged. If so, replace it
with new one.
Install the oil drain plug and tighten it.
Torque value: 3.5~4.5 kgf-m

CLEANING ENGINE OIL STRAINER

Remove the oil strainer cap.
Remove oil strainer and spring.
Clean oil strainer (recommended using
compressed air to clean dirty foreign).
Check if the strainer and O-ring of the oil
strainer are broken. Replace with new one if
found.
Install the oil strainer and spring.
Install the oil strainer cap and tighten it.
Oil strainer cap
Torque value: 1.0~2.0 kgf-m
Fill out oil to the oil filler (Oil viscosity SAE
10W-30).
Engine oil quantity: Replacement 700 c.c.
3-3