HW Group Poseidon 3265 Starting Manual

Poseidon 3265 – starting guide
Poseidon 3265
Starting Guide - Poseidon 3265
First steps for remote monitoring with Poseidon & GSM

1) Connecting Poseidon 3265

1.1) Check DIP switches settings. For installation keep them as
shown on the picture on the right (DIP1=Off, DIP2=Off).
1.2) RS-232 serial port for connecting GSM modem and setup
purposes.
1.3) Connect power adapter to power supply (230 /

110V) and to power jack of Poseidon. The connector
must be plugged in fully, green LED lights up.
1.4) Connect temperature or humidity sensor to IT bus
(Temp-1Wire or Humid-1Wire - RJ12 connector), the
connector must click.

1.5) Connect Poseidon to Ethernet (use direct
cable to Switch, cross-over cable to PC)
•
Green POWER LED on RJ45 connector lights up – power supply is OK
•
Yellow LED on the RJ45 connector blinks – connection to 10 Mbit network is OK
Accessories
GSM Modemcom G10
600 312
600 165 Poseidon 3265
600 313 Poseidon 3265 GSM2 Tset
600 005 Temp-1Wire 3m
600 311 Temp-1Wire-Outdoor 3m
600 279 Humid-1Wire 3m
600 040 Poseidon T-Box
600 280 Poseidon T-Box2
Oficjalny dystrybutor:
ATEL ELECTRONICS
Poseidon T-Box
600 040
Poseidon model 3265 unit with 5 sensors and GSM modem support
Start set - GSM modem, temperature sensors, power supply etc.
Temperature probe, 3m connecting cable (1m=600 242,10m=600 056)
Temperature probe for external use in food industry, cable 3m long
Humidity probe, extending cable 3m long(1m= 600 278)
Termination-Box for connecting up to 5 sensors, 10 cm long cable
Termination-Box for connecting 2 sensors, 3m long cable
www.atel.com.pl
e-mail: cust@atel.com.pl
HTemp-Rack19
600 330
Temp-1Wire 1m
600 242
45-231 Opole tel. +48 (77) 455 60 76
ul. Oleska 121 fax. +48 (77) 455 80 56
HW group
Humid-1Wire 3m
600 279