Table of Contents
Advertisement
Automatic spray gun A 10
Fig. 6: Adjusting the spray pattern
1.
Open the adjusting nut ( Fig. 6/3) of the needle stroke adjustment maximum 5.5 mm (
Fig. 6). To do so, turn the adjusting nut ( Fig. 6/3) counter-clockwise.
2.
Completely close the flat jet controller ( Fig. 6/1).
3.
Completely open the round jet controller( Fig. 6/2).
Do not close the round jet controller( Fig. 6/2) completely during operation.
4.
Adjust the flat jet on the flat jet controller ( Fig. 6/1).
5.
Continue adjusting settings on the controllers ( Fig. 6/1 and 2) until the desired spray pat-
tern is achieved.
It is recommended that you only adjust the spray pattern with the controllers ( Fig. 6/1
and 2). The fluid quantity should only be changed if the desired spray pattern cannot
be adjusted with the controllers ( Fig. 6/1 and 2). A limited fine adjustment, e.g. for the
coordination of several automatic spray guns in a system, can be made using the
adjustment nut ( Fig. 6/3).
■ 200-0148
ENGLISH
GB–25
Advertisement
Table of Contents
