Texas Instruments TI-Nspire Getting Started page 107

Shown on:
Both handhelds
Receiving
handheld
Receiving
handheld
Receiving
handheld
Receiving
handheld
Receiving
handheld
Message and Description
"Transfer failed. Check cable and try
The sending and/or receiving handheld is not
properly connected. Reinsert the cable into each
handheld, and then try the transmission again.
"You are receiving an OS Upgrade. Unsaved
changes will be lost.
Would you like to continue?"
This message is displayed when an OS Upgrade is
about to begin. If you do not select Yes within 30
seconds, the system automatically responds with
No.
"Receiving OS. Do not unplug cable."
This message, along with a progress bar, is
displayed while the OS Upgrade is being
transferred.
This message is displayed when the transfer is
complete. It is shown to keep you informed of the
handheld's status.
"OS has been installed. Handheld will
This information message displays briefly before
the handheld automatically reboots.
"Install was corrupted. Handheld will
reboot. You will need to retry OS upgrade."
An error occurred during the transmission and the
installation was corrupted. The handheld will
reboot. After the reboot, reinstall the OS Upgrade.
Updating the Handheld Operating System
again."
OK
Yes No
"Installing OS."
restart."
OK
OK
101