Output - Roland V-Drums TD-27 Data List

SYSTEM

OUTPUT

Here's how to assign the audio outputs from the MASTER OUT jacks, DIRECT OUT jacks, and PHONES jack.
Parameter
[F1] button (PAD MAS tab)
PAD OUTPUT ASSIGN MASTER
[F2] button (PAD DIR tab)
PAD OUTPUT ASSIGN DIRECT
[F3] button (OTHER MAS tab)
OTHER OUTPUT ASSIGN
MASTER
[F4] button (OTHER DIR tab)
OTHER OUTPUT ASSIGN
DIRECT
OUTPUT ROUTING
Here's how to make settings for output routing to the MASTER OUT jacks, DIRECT OUT jacks, and PHONES jack.
Parameter
[F1] button (ROUTING tab)
PadEq/Comp to Direct*1
PadComp to Phones
Master Out*1
[F2] button (LO CUT tab)
LoCut Frequency
DirectOut*2
MasterOut*2
PhonesOut
36
Value
PHONES (MASTER OFF),
PHONES+MASTER LR
OFF, 1, 2, 1+2, MASTER DIRECT L,
MASTER DIRECT R, MASTER DIRECT
L+R
PHONES (MASTER OFF),
PHONES+MASTER LR
OFF, 1, 2, 1+2, 3, 4, 3+4, 5, 6, 5+6, 7,
8, 7+8, MASTER DIRECT L, MASTER
DIRECT R, MASTER DIRECT L+R
Value
OFF, ON
OFF, ON
NORMAL, DIRECT
20–200 Hz
OFF, ON
OFF, ON
OFF, ON
Explanation
Specifies each pad's output from the PHONES jack and the MASTER OUT jacks (when Master Out
(p. 36) is "NORMAL").
Specifies each pad's output from the DIRECT OUT1, 2 jacks and the MASTER OUT jacks (when
Master Out (p. 36) is "DIRECT").
Specifies how ROOM and MFX are output from the PHONES jack and the MASTER OUT jacks (when
Master Out (p. 36) is "NORMAL").
Specifies how ROOM and MFX are output from the DIRECT OUT1, 2 jacks and the MASTER OUT jacks
(when Master Out (p. 36) is "DIRECT").
Explanation
Specifies whether the pad equalizer (p. 15) and pad compressor (p. 16) effects are applied (ON) or
are not applied (OFF) to the sound that is output from the DIRECT OUT jacks.
If this is "OFF, " the pad equalizer and pad compressor are bypassed for the output of the DIRECT
OUT jacks.
If the OUTPUT ROUTING Master Out is "DIRECT, " and PadEq/Comp to Direct is "OFF, " the output from
the MASTER OUT jacks also bypasses the pad equalizer and pad compressor.
Specifies whether the pad compressor (p. 16) is applied (ON) or is not applied (OFF) to the sound
that is output from the PHONES jack.
If this is "OFF, " the pad compressor does not affect the output from the PHONES jack.
For example, this lets you use the pad compressor to reduce the dynamic range for the drum
monitor or PA, but hear the full dynamics in the monitor headphones while you perform.
Selects whether the output of the MASTER OUT jacks is the same signal as the DIRECT OUT jacks
(DIRECT) or not (NORMAL).
If this is "DIRECT, " the output of the MASTER OUT jacks is not affected by the master compressor
and master EQ, allowing you to use the MASTER OUT jacks as DIRECT OUT jacks (the setting of the
[MASTER] knob does apply).
This setting also applies to the USB audio output to your computer.
Cuts the frequency region below the specified frequency (low cut).
This setting is common to all output jacks.
Specifies whether low cut is applied (ON) or is not applied (OFF) to the sound that is output from
the DIRECT OUT jacks.
Specifies whether low cut is applied (ON) or is not applied (OFF) to the sound that is output from
the MASTER OUT jacks.
Specifies whether low cut is applied (ON) or is not applied (OFF) to the sound that is output from
the PHONES jack.